Heated Floors

Due to limitations of the initial temperature of these heating systems can use all available sources of energy. Thanks to evenly distributed fairly large area of heat transfer are the best temperature conditions close to the optimal distribution of air temperature on the height of the room. Get all the facts and insights with Jack Monroe, another great source of information. The floor temperature must not exceed the allowable limit, as in this case will not be sustained given the project value temperature heating registers, embedded in floors, and can occur not only breach the state of the floor construction, but also damage human health. Valid values for the surface temperature of heated floors: surfaces for floors with normal operating conditions not exceeding 28 C for baths, swimming pools and bathrooms not exceeding 33 C for seldom-used areas of the premises along the walls and windows in the area not exceeding 38 C. When choosing construction of heated floors and heating system they must first address the following questions: Is this the main heating and this additional heating, which will then be used coolant (hot water, electric heating, air heating, or others) which provides for heat transfer (direct heat transfer or slow heating), in which the premises are planning to carry out such floor (housing, room or outbuildings, swimming pools or bathrooms, open area). what kind of energy will be used to generate heat.

There are various heating, built in floor systems, for example, circulating hot water, in which the details of fluid transport systems and devices working together, and technology fit together. The main part of such system is the conduit that was previously made of high-quality materials, and now mostly made of special plastics. The durability of these systems on design parameters is about 50 years, but the stability of pipelines to mechanical stress, Effects of temperature, corrosion and aging attach great importance because it affects accident-free operation of the heating system. Given that the heating system is integrated directly into the construction of gender, so after the installation of the device in front of ties to carry out tests and check the pressure of the special committee with a representative Gosgortechnadzor and draw up a statement of acceptance of papers. When using electrical systems, built into the design of floor screed, the most important criteria are the stability and design of heat tie, as the temperature of electric heaters may be much higher temperature pipes. The main part of such an electric cable heating systems, strengthened by reinforcing the grid in the form of a flat single coil to be placed in the screed. The unit of heating systems is much easier to technology, and assembly yields of standardization and unification, heaters are sectional, the presence of metal mesh improves the structural work ties. Floors with built-in heating system are effective, but a complex structure, organized on the grounds of bearing floors and consists of three parts, alternately or simultaneously performed at the facility. Requires strict coordination and coherence in work when the installation of heating, creating a cement-sand screed and monolithic flooring. Any heating system during installation is placed in-situ cement-sand screeds, which are middle part of the floor construction being done on site, or heating elements embedded in a prefabricated tie in their manufacture industrial methods for precast concrete factories.